12 Şubat 2019 Salı

How To Make A Line Follower Car?

How To make An Arduino Line Follower Robo Car?

Hello, with this Project you can make your own Arduino Line Follower Robo Car. This Project need mediacore Arduino knowledge. The line followercar requirements as below:

1x Arduino Uno (https://goo.gl/VHwGMK)
1xL298N Motor Driver (https://goo.gl/24dyj6)
2x100 RPM Dc Motor with Wheels (https://goo.gl/WNRM2C)
2x Reflection Sensor (https://goo.gl/i9V4sQ )
1x idler Wheel
1x 7,4 Li-po Battery
1xtiny breadboard
1xCar chassis
Hot Glue
Soldering Iron
Jumper Cables
And  some time.

First print 3D Car Chassis. Hot glue DC motors and plug whells to 3D printed chassis below. Solder DC motor anot and catot with jumper cables. Connect them on the tiny breadboard. Connect li-po battery to L298N motor driver +12V and GND port. Plug a jumper cable to +5v and GND to L298N and connect them Arduino Uno’s (5V to Vin and GND to GND) pins. Hot glue idler whell to chassis. Hot Glue motor driver, Arduino and lipo on the chassis. Upload this code to Arduino. And its ready to go. You can put a switch between lipo and motor driver. Not you can test this Arduino Line Following Robo Car with a parkour. Make your own line parkour with some  tape.